Don't come back to a dead battery because you forgot to turn off the baggage light...

XAGYL's computer-controlled dome light controller adds many advanced features to standard interior lighting, without the cost of replacing the lights to newer fixtures.

The digital controller provides the following:

• A programmable system timeout will turn off all the lights automatically when on battery after 1 to 10 minutes, in selectable in 1 minute increments
• Supports up to 7 illuminated momentary switches for pilot, copilot, left rear passenger, right rear passenger, baggage, left step and right step
  
• Supports up to 7 lights lights for pilot, copilot, two rear passengers, baggage, left step, right step and switch illumination
• Supports either a button switch or a plunger switch for the baggage door
• All lights are individually dimmable, except the two step lights which are always at full brightness
• Each light's intensity is stored and reused on subsequent operation
• PWM output which is compatible with LED and incandescent bulbs
• Each light can be individually set for gradual ON/OFF or instantaneous ON/OFF action
• The step switches have three programmable function modes:
1. Left step and pilot or right step and copilot lights
2. Both steps and pilot and copilot lights
3. All lights at once
• The step switches have a programmable timeout from 1 to 10 minutes set in 1 minute increments
• Each switch can turn ON or turn OFF all lights simultaneously using an extended press
• Switch LEDs are only illuminated when the engine is running to conserve the battery
  
• A critical low voltage detection will turn off all lights immediately and restore them after the bus voltage recovers, either as a result of starting the engine or alternator failure in flight
• An S.O.S. mode will activate all lights into an SOS flashing pattern until either turned off, or the battery reaches a critical voltage level
• Compatible with both 14V and 28V aircraft electrical systems

Controller weighs 0.4lbs and measures 3" x 4" x 0.75".

The kit includes the controller, mil-spec connector, crimp pins and back shell.

Switches are available separately.